Behringer FCB1010 Manuel d'utilisateur télécharger pdf (Page 12)

MIDI FOOT CONTROLLER FCB1010

Fig. 2.5: Sending a SysEx-Dump

2.7.2 Receiving SysEx dumps

To send back FCB1010 data stored on a sequencer/computer

before, please follow the instructions below:

s Connect the MIDI OUT connector of your sequencer or

computer to the MIDI IN connector of the FCB1010

(see fig. 2.6).

s Keep the DOWN switch pressed during power-up to enter

the GLOBAL CONFIGURATION menu.

s Press UP until the CONFIGURATION LED lights up. Now the

unit is in CONFIGURATION mode.

s Press footswitch #7 (SYSEX RCV) to tell the FCB1010 to

wait for system-exclusive data (the footswitch LED lights

up). Start the PLAYBACK function on your sequencer/

computer to play back the previously stored file. The foot-

switch LED flashes while the FCB1010 is receiving data.

Once the data have been received correctly, the LED dies

out. Now your programs are back in the FCB1010s memory.

Quit GLOBAL CONFIGURATION mode by means of a long

press on DOWN.

Fig. 2.6: Receiving a SysEx dump

2.8 Restoring factory presets

This function allows you to restore factory defaults of your

FCB1010.

+ In doing so, all preset settings made by you are

overwritten!

Resetting your FCB1010 lets you restore various default

settings that are optimized for use with BEHRINGER audio

equipment. This is why there are three different key combinations

that let you reload the desired defaults into the memory of your

FCB1010. This key combinations are shown in table 2.5:

1 + 6 V-AMP family products

1 + 7 BEHRINGER guitar amps

1 + 8 BASS V-AMP product range

Tab. 2.5: Reset key combinations

Keep the respective footswitches pressed for roughly 2.5

sec while powering up your FCB1010. The displays reads 09

to 00 and the points are blinking. When the points are no longer

shown, your FCB1010 has been reset to factory defaults and is

ready for operation.

2.9 Calibrating expression pedals A and B

Should you experience problems with exact MIDI controller

data transmission while using the expression pedals, we

recommend calibrating the pedals. Calibrating the pedals follows

the complition of the FCB1010 self-test.

+ All software versions 1.4 and newer allow for direct

calibration by keeping the switches 1 and 5 pressed

while powering up the unit. If your FCB1010 features

the software version 1.4 or higher, skip the first 4

steps in the set of instructions that follow (i.e. start

at point number 5). To find if your unit features

version 1.4 or higher of the software, first try

keeping the switches 1 and 5 pressed while

powering up the unit. If nothing happens, start

calibrating your FCB1010 beginning with the first

step in the list that follows.

2. PROGRAMMING THE FCB1010

1 2 ... 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Behringer FCB1010 Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs et amplificateurs Behringer FCB1010