Behringer U-PHONO UFO202 Manuel d'utilisateur télécharger pdf (Page 10)

10 U-PHONO UFO202 User Manual

(4) LINE/PHONO SWITCH: Move the switch on the top left

to PHONO if transferring from a record player. For all other

sources, select LINE.

◊ Note: The PHONO inputs only support moving

magnet cartridges. These are the most common type,

so unless you know your player uses a moving coil

cartridge, assume that your system will work.

(5) HEADPHONES OUTPUT: Plug your headphones into the

PHONES output using a �" mini plug.

(6) HEADPHONES VOLUME: Adjust the headphones volume

with the adjacentcontrol.

(7) USB CABLE: Plug the USB cable into a free USB port on

yourcomputer.

(8) POWER INDICATOR: Upon connection, the UFO’s

power indicator will light up and the computer should

automatically recognize the connection.

4. Software Installation

• This device requires no special setup or drivers, just plug it

into afree USBport on a PC or Mac computer

• The UFO202 comes with a free version of Audacity editing

software. This will help make the transfer process quick

and simple. Simply insert the install CD into your CD-ROM

drive and follow the instructions. The CD also contains VST

plug-ins, ASIOdrivers and various freeware

5. Hookup Diagram

5.1 Hooking up a record player

1. To transfer music from a record player, a special

preamplication process must take place in order to boost

the low signal level coming from the player. To do this,

simplymove the LINE/PHONO switch on the UFO202 to the

right(PHONOselected).

2. Connect a stereo RCA cable from the record player outputs

to the RCA inputs on the UFO202. The player will also likely

have a ground cable that needs to be attached to the

ground terminal on the UFO202.

Headphone Out

RCA Outputs

RCA InsGround

Line/Phono

Computer USB

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Behringer U-PHONO UFO202 Manuel d'utilisateur Page 10