14 XENYX XL3200/XL2400/XL1600 User Manual
5.5 Su/jointfilesconvert/576729/bgroups
The XENYX provides 4 su/jointfilesconvert/576729/bgroups which allow you to feed multiple channels
to mono or stereo mixdowns. Their volume level can be adjusted using the
su/jointfilesconvert/576729/bgroup faders. For example, createa subgroup with all vocal channels or drum
signals and adjust the volume using the su/jointfilesconvert/576729/bgroup fader. This way you can keep
track and, at the same time, can process the signal with a compressor via the
su/jointfilesconvert/576729/bgroup insert.
Additionally, you can also use the su/jointfilesconvert/576729/bgroup outputs as sends for a
multitrackrecorder.
PAN
The PAN control adjusts the position within the stereo image.
MAIN
The MAIN switch routes the su/jointfilesconvert/576729/bgroup signal to the main mix.
With the PAN control you can adjust the signal to the left side of the stereo
image (PAN turned fully left), to the right side of the stereo image (PAN turned
fully right) or to both sides (PAN in center position) of the stereo main mix.
Forexample, when creating a stereo submix with the su/jointfilesconvert/576729/bgroups 1 and 2, group1
should be adjusted to the left and group 2 to the right side of the main mix in
order to maintain a balanced stereo image. In case you have created a mono
submix with only one su/jointfilesconvert/576729/bgroup, be sure to center the PAN control so that the
signal is not only heard on one side.
SOLO
The SOLO switch routes the subgroup signal to the AFL bus (Solo In Place) orPFL
bus (Pre Fader Listen), so that you can monitor the su/jointfilesconvert/576729/bgroup signal without
aecting the main or sub output signals. The signal to be monitored is taken
either pre (PFL, mono) or post-su/jointfilesconvert/576729/bgroup fader (Solo, stereo), depending on the
position of the SOLO/PFL switch. The SOLO LED illuminates when the SOLO switch
is pressed.
CLIP
The CLIP LED lights up as soon as the su/jointfilesconvert/576729/bgroup signal's level is too high.
Inthiscase, pull down the channels' faders routed to this group.
SIG
The SIG LED lights up when a signal is routed to the su/jointfilesconvert/576729/bgroup whose level is
higher than -20 dB.
◊ The signal and clip LEDs are not affected by the fader. The signals are
indicated even when the su/jointfilesconvert/576729/bgroup fader is pulled down.
Fader
The su/jointfilesconvert/576729/bgroup faders adjust the volume level of the su/jointfilesconvert/576729/bgroup signal at the
su/jointfilesconvert/576729/bgroup output. If the MAIN switch is pressed, you can also adjust the
su/jointfilesconvert/576729/bgroup's volume level in the main mix.
5.6 Further functions of the mastersection
5.6.1 Talkback
The talkback function of the XENYX allows you to communicate with people on
stage. The talkback signal can be routed to the dierent bus outputs.
MIC
Here you can plug in the microphone for talkback use.
LEVEL
The LEVEL control adjusts the volume level of the talkbacksignal.
Commentaires sur ces manuels